"Protect" sunscreen
This non-greasy sun milk combines the benefits of organic and inorganic UV filters, achieving reliable broad-spectrum sun protection and protecting the skin against cellular damage and premature skin aging.
Estimated SPF*: 25

Difficulty level: ⭐⭐ medium
Preparation time: ⏱ approx. 35 minutes
SunLite and SunZinc protect the skin from both UVA and UVB radiation and work synergistically.
Sunwell and Antileukine 6 provide moisturizing and soothing effects, protecting the skin from sun-induced damage.
Sepinov WEO acts as a co-emulsifier and ensures excellent stabilization of the UV filters in the emulsion.
Glycogreen and SLG act as emulsifiers here and enable the easy cold processing of the product.
Raw materials in percent:
| % | ||
|
A1
|
Pentylene Glycol Green | 2 |
| Preblend Easy | 1 | |
| Sunwell | 2 | |
| GlycoGreen | 0.5 | |
| Sodium Stearoyl Glutamate | 0.1 | |
|
A2
|
Distilled water | 63.1 |
| Citric acid | q.s. | |
| A3 | SolarLite | 10 |
|
B
|
SolarZinc | 12 |
| Lipoblend Hydrosoft | 2 | |
| Lipoblend Ultralite | 2 | |
| Liposens | 2 | |
| Antileukine 6 | 2 | |
| Sepinov WEO | 1.3 | |
| Total | 100 |
Instructions:
Weigh and stir A1
Weigh A2, add, and adjust the pH value to approx. 5.5 using citric acid
Add A2 to A1 and stir
Add A3 and stir in thoroughly
Weigh and stir B
Add A to B while stirring gently
Let swell for approx. 15 minutes, stirring occasionally
Then homogenize thoroughly with a mixer
Check/adjust the pH value again
Important note:
*) An exact SPF can only be determined through in vivo tests in a laboratory. The estimated SPF is derived from the theoretical, calculated assessment based on the usage concentration. However, the overall formulation and processing method are also essential for the actual SPF, which may differ significantly under certain circumstances. Water resistance and rub resistance are also verified by independent institutes. Therefore, we cannot provide any guarantee for the actual protective effect of this product and advise careful handling of UV radiation.
TIP:
Sepinov WEO serves here as both a gelling agent and emulsifier. Gels created with Sepinov WEO can incorporate small amounts of oil without the additional use of an emulsifier. However, the processing method is important. Add it to the oil phase and immediately emulsify the water phase right after you have combined the water and oil phases. SolarLite is an already pre-emulsified, oil-soluble sun filter, present as an aqueous emulsion. Therefore, it can also be easily incorporated into this gel-cream and actually aids in emulsion formation; however, it slightly delays the gel formation, thus giving the gelling agents enough time to swell in the water!
Leave a comment